Avaya 16-300310 manual Mcudisplayname Polycom RMX-2000

Configure H.323 video endpoints on Communication Manager 6.0

Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform

4	Use the change trunk-group n command (where n is the trunk group you added in
	Step 2) to add members to the trunk group. The number of members depends on the
	maximum simultaneous calls an RMX supports.
5	Use the change route-pattern n command (where nis the route pattern you want
	to use) to create a route pattern that points to the two-way trunk group.
6	Install the Polycom system and connect it to your network.
7	Upgrade the Polycom system software (if necessary).
8	Access the Polycom home page for the unit.
9	From the Setup menu, select the System Configuration tab.
10	Under the MCMS_PARAMETERS_USER, configure the following settings:
	● MCU_DISPLAY_NAME: POLYCOM RMX-2000
	● ENABLE_AUTO_EXTENSION: YES
	●	NUMERIC_CONF_ID_LEN: 5
	● CP_REGARD_TO_INCOMING_SETUP_RATE: NO
	●	NUMERIC_CONF_ID_MAX_LEN: 8
	●	NUMERIC_CONF_ID_MIN_LEN: 4
	● TERMINATE_CONF_AFTER_CHAIR_DROP: NO
	●	H323_FREE_VIDEO_RESOURCES: NO
11	Under CS_MODULE_PARAMETERS, add:H245_TUNNELING: YES
12	Create an H.323 service, and enter the CLAN or PROCR IP address of the
	Communication Manager system as the primary gatekeeper. Confirm through a status
	signaling group that the RMX has registered.
13	Create a meeting room to use a test direct dial conference ID.

AVTS R 6.0 Quick Setup For feedback, use document@avaya.com August 2010 18