
TALK
When you receive a call, Incoming Call appears on the display. To answer it, lift the handset from the base and press TALK. If auto talk is on, just lift the handset from the base or press any key.
To end a call, place the handset on the base or press TALK.
ADJUSTING THE HANDSET VOLUME
To adjust the volume you hear through the handset during a call, press VOL/CID 8 to increase or 9 to decrease the volume. The display shows Volume Maximum, Vol- ume High, Volume Medium, or Vol- ume Low.
Note: When you press VOL/CID 8 while the volume is maximum or VOL/CID 9 while the volume is low, the setting does not change.
Note: If the handset is too far from the base, the channel might not change. Move closer to the base and try again.
ANSWERING CALLS WITH THE SPEAKERPHONE
To answer a call using the speakerphone, press SPEAKER. The SPEAKER indicator lights.
SPEAKER
To adjust the speakerphone’s volume, re- peatedly press VOLUME 8 or 9 on the base. The volume setting from 1 (lowest) to 10 (highest) appears in the message counter window.
VOLUME
SELECTING THE CHANNEL
The phone scans 20 channels (frequency pairs used between the base and the hand- set) and automatically selects a clear chan- nel each time you make or receive a call.
If you hear other conversations or excessive noise during a call, press CH/SELECT to se- lect a different channel. The display shows Scanning.
To end a speakerphone call, press SPEAKER again.
Telephone Operation | 15 |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|