Radio Shack 900 MHz owner manual Replacing the Battery Pack

Page 30

43-749.fm Page 30 Tuesday, September 5, 2000 11:24 AM

REPLACING THE BATTERY PACK

If you follow the instructions in “Connecting and Charging the Battery Pack” on Page 10, the battery pack should last about one year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new 3.6-volt, 600 mAh bat- tery pack with a connector that fits the socket in the battery compartment. You can order a replacement battery pack through your local RadioShack store.

Install the new battery pack as described be- low, then charge it for about 24 hours (see “Connecting and Charging the Battery Pack” on Page 10).

Note: To avoid losing memory numbers, in- stall and begin charging the new battery pack within 2 minute.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the compart- ment, then gently pull on the battery connector to disconnect it.

3.Insert the new battery pack’s connector into the socket in the compartment, place the battery pack into the compart- ment.

4.Replace the cover.

If you have trouble replacing the battery, take the answering system to your local Ra- dioShack store for assistance.

Cautions:

You must use a replacement battery of the same size and type.

Do not dispose of the battery in a fire because it might explode.

Do not open or mutilate the battery.

Be careful not to short the battery by touching the connector’s pins with con- ducting materials, such as rings, brace- lets, and keys. The battery pack or conductor might overheat and burn.

Important: This product can

use nickel-cadmium re- chargeable batteries. At the end of a nickel-cadmium

battery’s useful life, it must be recycled or disposed of

properly. Contact your lo-

cal, county, or state hazardous waste man- agement authorities for information on recycling or disposal programs in your area or call 1-800-843-7422. Some options that might be available are: municipal curbside collection, drop-off boxes at retailers such as your local RadioShack store, recycling col- lection centers, and mail-back programs.

30

Care and Maintenance

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 30
Contents MHz Digital Spread Spectrum Digital Answering System Contents Answering System Operation Features Telephone FeaturesAnswering System Features Read this Before InstallationImportant Caller ID Information Important Safety Instructions FCC StatementFm Page 7 Tuesday, September 5, 2000 1124 AM Installation Mounting the PhoneOn a Desk Top Connecting and Charging the Battery Pack Setting the Dialing Mode Setting the Number of Rings Setting the HANDSET’S Ringer TONE/VOLUMETurning the BASE’S Ringer on and OFF Setting the DAY/TIME Setting Auto TalkTelephone Operation Turning Caller ID/CALL Waiting on or OFFStoring Your Area Code Adjusting the Handset Volume Answering Calls with the SpeakerphoneSelecting the Channel Using Flash Switching Between the Handset and SpeakerphoneUsing Both the Handset and Speakerphone Using RedialUsing a Headset PagingMemory Dialing Storing a Name and Number in MemoryEditing or Deleting a Number in Memory Entering a PauseReviewing Memory Numbers Caller ID Operation Dialing a Memory NumberReviewing Caller ID Records Dialing Numbers from a Caller ID Record Caller ID MessagesADDING/DELETING the Area Code Storing a Caller ID Record to MemoryDeleting Caller ID Records Setting the Record TimeAnswering System Operation Selecting the Outgoing MessageSetting the Answering System to Answer Calls Screening CallsRecording Incoming Messages Recording a Memo Recording a ConversationPlaying Messages Adjusting the Answering SYSTEM’S Volume Deleting MessagesRemote Operation Using Remote Commands Troubleshooting Problem SuggestionBe sure the battery pack is correctly connected Care and Maintenance Replacing the Battery Pack FCC Wants YOU to Know LightningLimited One-Year Warranty