GE 2-9191 manual FCC Registration Information, Notification to the Local Telephone Company

Page 2

FCC REGISTRATION INFORMATION

Your telephone equipment is registered with the Federal Communications Commission and is in compliance with parts 15 and 68, FCC Rules and Regulations.

1Notification to the Local Telephone Company

On the bottom of this equipment is a label indicating, among other information, the FCC Registration number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company. The REN is useful in determining the number of devices you may connect to your telephone line and still have all of these devices ring when your telephone number is called. In most (but not all) areas, the sum of the RENs of all devices connected to one line should not exceed 5. To be certain of the number of devices you may connect to your line as determined by the REN, you should contact your local telephone company.

Notes

This equipment may not be used on coin service provided by the telephone company.

Party lines are subject to state tariffs, and therefore, you may not be able to use your own telephone equipment if you are on a party line. Check with your local telephone company.

Notice must be given to the telephone company upon permanent disconnection of your telephone from your line.

2Rights of the Telephone Company

Should your equipment cause trouble on your line which may harm the telephone network, the telephone company shall, where practicable, notify you that temporary discontinuance of service may be required. Where prior notice is not practicable and the circumstances warrant such action, the telephone company may temporarily discontinue service immediately. In case of such temporary discontinuance, the telephone company must: (1) promptly notify you of such temporary discontinuance;

(2) afford you the opportunity to correct the situation; and (3) inform you of your right to bring a complaint to the Commission pursuant to procedures set forth in Subpart E of Part 68, FCC Rules and Regulations.

The telephone company may make changes in its communica- tions facilities, equipment, operations of procedures where such action is required in the operation of its business and not inconsistent with FCC Rules and Regulations. If these changes are expected to affect the use or performance of your telephone equipment, the telephone company must give you adequate notice, in writing, to allow you to maintain uninterrupted service.

FCC NUMBER IS LOCATED ON THE CABINET BOTTOM REN NUMBER IS LOCATED ON THE CABINET BOTTOM

2

Image 2
Contents 9191 FCC Registration Information Notification to the Local Telephone CompanyInterference Information Hearing AID CompatibilityTable of Contents Introduction Caller ID with Call WaitingModular Jack Requirements Parts ChecklistBefore YOU Begin Installing the Batteries Installation & SetupImportant Installation Information Setting UP the Caller ID Menu Exit SetupTo SET Your Local Area Code To SET the CID Display LanguageTo SET the LCD Contrast To SET the Dial ModeTo Exit Setup Installing the Phone To Install on a DesktopTo Mount on a Wall Summary Screen Caller ID FeaturesUsing the Caller ID Button Receiving and Storing CallsDeleting Call Records If YOU Programmed Your Local Area Code in the Setup MenuReviewing Call Records Dialing BackDigits Smith John Message Indicators Unknown CallTelephone Basics Changing the VolumeUsing ONE Touch Redial Redialing a NumberTo Store Frequently Called Numbers Using Memory FeaturesTo Store EMERGENCY/QUICK Dial Numbers To Dial a Quick Dial Number To Change a Stored NumberTo Erase a Stored Number To Dial Frequently Called NumbersFlash To USE Temporary Tone DialingNo Dial Tone Troubleshooting TipsError Message is Displayed No DisplayPhone does not Dial OUT Incoming and Outgoing Voice Volume LOWTone Feedback Flutter When Dialing in Pulse Mode Phone does not RingService Index Page Limited Warranty For how long after your purchaseModel Rev E/S 99-34 9191 El numero REN esta ubicado en el fondo de la base Información DE Interferencias Compatibilidad CON AudífonosTabla DE Contenido Instalación YprogramaciónIntroducción Identificación DE Llamadas CON Llamada EN EsperaLista DE Partes Antes DE ComenzarInstalación Yprogramación Requerimientos DE Contacto ModularInstalación DE LAS Baterías Para Programar EL Menú DEL Identificador DE Llamadas Oprima y sostenga la ecla de revisarPara Programar SU Código DE Área Local LCD Contrast Para Programar LA Modalidad Para Marcar Para Instalar EL Teléfono Para Instalar Sobre Superficie PlanaPara Montar Sobre Pared Para Recibir Y Almacenar Llamadas Funciones DEL Identificador DEProgramación DEL Llamadas Para Usar EL Botón DEL Caller IDPara Discar Contestar Para Revisar Datos DE LlamadasPara Borrar Datos DE Llamadas Dígitosnúmero telefónico de 7 dígitos por ejemplo Llamada EN Espera CON Identificación DE Llamada Mensajes Indicadores DesconocidaPara RE-DISCAR UN Número Para Cambiar EL VolumenInformación Básica DEL Teléfono RE-DISCADO CON UNA TeclaNúmeros DE EMERGENCIA/DISCADO Rápido Para Usar Funciones DE LA MemoriaNúmeros Frecuentemente Discados Para Discar UN Número DE Discado Rápido Cómo Cambiar UN Número AlmacenadoPara Borrar UN Número Almacenado Para Discar Números Llamados FrecuentementeCentelleo Flash Tono Temporario Para DiscarDetección DE Averías Cómo Obtener Servicios DE Mantenimiento Indice Page Garantía Limitada Vigencia de la garantíaBox 1976, Indianapolis,