Plantronics 510S setup guide Features and Options

Page 16

Features and Options

Re-dialing last number

•To activate last number re-dial, double click the Call Control Button. You will hear a high tone for each key press. When you hear another tone, the last number has been re-dialed.

Using voice dialing

•To activate voice dialing, press and hold the Call Control Button for 2 seconds until you hear a second tone.

Note: To use voice dialing, the voice dialing feature must be enabled on your phone.

(This feature must be supported by both your carrier and cell phone. See your phone manual for instructions).

Rejecting a call

•When receiving an incoming call, press and hold the Call Control Button. When you hear two tones, the call has been rejected and you can release the button.

Transferring a call from your mobile phone to your headset

•To transfer an active call from your mobile phone to your headset, press the Call Control Button for more than 2 seconds.

Transferring a call from your headset to your mobile phone

•To transfer an active call from your headset to your mobile phone, press the Call Control Button for more than 2 seconds.

Muting a call

•To mute a call, press the Power/Mute button for less than 1 second. A single high tone followed by a single low tone will sound.

•To take a call off of mute, press the Power/Mute button again for less than 1 second. A single low tone followed by a single high tone will sound.

•Mute Reminder — A double low tone will sound every 30 seconds as a reminder that mute is activated.

To Disable Online and Standby Indicator Lights

•When purchased, the headset will have the online and standby indicator lights enabled. To disable these indicators, press the volume up button while turning the headset on. To re-enable both indicator lights, turn the headset off; then press the volume up button again while turning the headset on.

Note: This process only disables online and standby indicator lights when headset is connected to a Bluetooth device, such as a mobile phone or base. All other indicator lights, such as low battery, will continue to function.

16Plantronics Voyager 510S Setup Guide

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Easy Steps Plantronics Voyager 510S Package Contents Install Eartip & Adjust fit To Install a Different EartipFit the Headset To Convert for Wearing on Left EarConfiguration a 2Connect Base to Desk PhoneConfiguration B Handset port or Headset port?3Connect Power and Charge Headset Connect Headset Base to power outletCharge the Headset for at least 20 Minutes before using Base Power AdapterConnect Handset Lifter power cord to Headset Base 4Install Automatic Handset LifterAutomatic Handset Lifter Determine Lifter position and height setting Power/MuteButton Lifter viewed Start with Lifter From backIf you do not hear a dial tone Use the Extender Arm to Stabilize Handset if needed Mount the Lifter in permanent positionPlacing, Answering, or Ending Calls on your Desk Phone Using your Voyager 510S Headset with your desk phoneMuting a Call Adjust Listening Volume Adjust Speaking VolumeTo Fine Tune Listening Volume Listening Volume Button Set the IntelliStandtm Feature To Fine Tune Speaking Volume Speaking Volume Minor Adjustment Control IntelliStand SwitchPairing Headset and Base Speaking VolumeMinor Adjust ButtonsPairing your Voyager headset to your Bluetooth mobile phone Features and Options Indicator Lights Low Battery WarningVoyager 510S Lights and Tones Out of Range WarningTroubleshooting and Common Questions Can’t hear a dial tone at the headsetStill having problems? Plantronics Limited WarrantyMaintenance Battery replacementPlantronics, Inc Encinal Street Santa Cruz, CA 95060 USA
Related manuals
Manual 15 pages 58.99 Kb
Top Page Image Contents