Honeywell 9900 manual Comm Section

Comm Section

The serial port settings in the Comm section determine the interaction between ScanWedge and the serial port.

Comm Section	Description	Default	Available Values
Key		Value
Enable	Enables (or disables) ScanWedge to	0	0=Disabled; no data is received
	receive and interpret data from the		1=Enabled; ScanWedge receives
	serial port.		data from the serial port
			(specified in the Port key) as
			keystrokes to the foreground
			application.
AutoConnect	Enables or disables the auto-	0	0=Disabled; ScanWedge opens the
	connection between ScanWedge		serial port immediately at startup
	and the serial port.		and doesn’t close until
			ScanWedge is closed. This is the
			recommended setting when the
			serial port is port 2 or 3.
			1=Enabled; ScanWedge connects to
			the serial port when a power
			source is detected and
			disconnects when the power
			source is removed/not detected.
Port	Specifies the serial port to use to		The use of port 4/6 is not
	connect to ScanWedge.		encouraged.
	Note: This setting is ignored for Port 4.
FlowControl	Specifies the flow control method to	4	1=Software (Xon-Xoff)
	use–software only, hardware only, or		2=Hardware
	software and hardware.		3=Hardware and software
	Note: This setting is ignored for Port 4.		4=No flow control
BaudRate	Specifies the baud rate for the serial	38400	X=The appropriate baud rate.
	port.
	Note: This setting is ignored for Port 4.
Parity	Specified the parity for the connection.	0	0=No parity
			1=Odd parity
	Note: This setting is ignored for Port 4.		2=Even parity
			3=Mark parity
			4=Space parity
DataBits	Specifies the number of bits per byte to	8	X=Number of bits per byte
	use.
	Note: This setting is ignored for Port 4.
StopBits	Specified the number of stop bits to	0	0=1 stop bit
	use.		1=1.5 stop bits
			2=2 stop bits
	Note: This setting is ignored for Port 4.

5 - 6	Rev A	Dolphin® Power Tools User’s Guide
	8/6/08