Honeywell 9900 manual AimerDurationALR, AimerDelayALR, DefaultEnabledSymbo, Logies

Decode Section

The Decode section specifies decoder settings when using the decoder with ScanWedge.

ScanWedge Entry	Description	Default	Available Values
		Value
AimerDuration	The number of milliseconds the	0
	scanner aimer is displayed, after the	[Decode
	trigger key has been pressed down,	begins
	before attempting to decode a
		instantly.
	barcode.
		]
AimerDelay	The amount of time between scans	500	Enter times in 1/1000th of a
	before the aimer turns on again.
			second.
AimerDurationALR	The amount of time the aimer stays	2000
	on. This setting is for an ALR
	decoder.
AimerDelayALR	The amount of time between scans	500
	before the aimer turns on again.
	This setting is for an ALR decoder.
DefaultEnabledSymbo	Specifies which symbologies should	0	0=Use internal list
logies	be enabled before processing the		1=All symbologies are disabled
	Symbologies section.		initially. Enable specific
			symbologies in the
	See Symbologies Section on page 5-		Symbologies section.
	17.		2=All symbologies are enabled
			initially. Disable specific
			symbologies in the
			Symbologies section.
EnablePrefixData	Enables or disables all prefix data	1	0=Disabled
	received from the decoder after a		1=Enabled
	successful scan.
	All prefix data is defined in the
	Settings Section (see page 5-3).
EnableSuffixData	Enables or disables all suffix data	1	0=Disabled
	received via decoder after a		1=Enabled
	successful scan.
	All suffix data is defined in the
	Settings Section (see page 5-3).

Dolphin® Power Tools User’s Guide	Rev A	5 - 9
	8/6/08