TP-Link manual The Rear Panel, TL-WA730RE 150Mbps Wireless Range Extender User Guide

Page 13

1.3.2 The Rear Panel

TL-WA730RE150Mbps Wireless Range Extender User Guide

1.3.2 The Rear Panel

Figure 1-2

Viewed from left to right, the following parts are located on the rear panel of TL-WA730RE.

POWER: The power port connects to the power adapter provided with the TL-WA730RE 150Mbps Wireless Range Extender.

LAN: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.

RESET: The Reset button is used to restore the AP’s factory default settings. There are two ways to reset the Access Point’s factory defaults:

zMethod one: With the AP powered on, use a pin to press and hold the Reset button (about 5 seconds) until the System LED becomes quick-flash from slow-flash. And then release the button and wait the router to reboot to its factory default settings.

zMethod two: Restore the default settings from “System Tools > Factory Defaults” of the Modem's Web-based management page.

Wireless antenna: The external antenna is used to transmit and receive wireless data.

)Note:

Ensure the Range Extender is powered on before it restarts completely.

6

Image 13

Contents Rev 1.0.0 TL-WA730RE 150Mbps Wireless Range ExtenderAll rights reserved COPYRIGHT & TRADEMARKSCE Mark Warning FCC STATEMENTFCC RF Radiation Exposure Statement Country National restrictionsRestriction Reason/remarkProduct Description 150Mbps Wireless Range Extender DECLARATION OF CONFORMITYETSI EN 300 328 V1.7.1 ETSI EN 301 489-1 V1.8.12008& ETSI EN 301 489-17 EN60950-12006Package Contents CONTENTSHardware Installation Chapter 3 Quick Installation GuideAppendix C Troubleshooting Appendix B Factory DefaultsAppendix D Specifications Appendix A Application ExampleConventions Package ContentsPackage Contents Overview of This GuideChapter 2 Hardware Installation Chapter3 Quick Installation Guide4.6 DHCP Introduces how to set your AP to be a DHCP server sothat the AP will automatically assign an IP address for your PCFeatures 1.2 Main FeaturesChapter 1 Introduction 1.1 Product Overview1.3.1 The Front Panel 1.3 AppearanceTL-WA730RE 150Mbps Wireless Range Extender User Guide LED ExplanationEnsure the Range Extender is powered on before it restarts completely 1.3.2 The Rear Panel2.3 Connecting the Device Chapter 2 Hardware Installation2.1 Before You Begin 2.2 Basic Requirements1. Connect the Cable or DSL modem to a Router 3.1 Configure the PC Chapter 3 Quick Installation GuideTL-WA730RE 1 Select Use the following IP address 3.2 Quick Setup Figure 3-9 Quick Setup Figure 3-11 AP List Figure 3-12 Quick Setup - Range Extender ModeB. When you choose Access Point, take the following steps TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.1 Status Chapter 4 Configure the Device4.3 QSS 4.2 Quick SetupMethod One To add a new deviceFigure 4-3 Add A New Device Next TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.4 Network 4.5.1 Wireless Settings 4.5 WirelessTL-WA730RE 150Mbps Wireless Range Extender User Guide TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.2 Wireless Security 1 Range Extender ¾ WPA-PSK/ WPA2-PSK - Select WPA based on pre-shared key 2 Access Point TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.3 Wireless MAC Filtering To modify or delete an existing entry To set up an entry, follow these instructions4.5.4 Wireless Advanced 4.5.5 Throughput Monitor 4.5.6 Wireless Statistics This page will be refreshed automatically every 5 seconds 4.6 DHCP4.6.1 DHCP Settings 4.6.3 Address Reservation 4.6.2 DHCP Clients ListThe changes wont take effect until the device reboots 4.7 System ToolsTo Reserve IP addresses To modify A Reserved IP address4.7.1 SNMP 4.7.2 Diagnostic Figure 4-23 Diagnostic 1 Only one user can use this tool at one time 4.7.3 Ping Watch Dog4.7.4 Firmware Upgrade 4.7.6 Backup & Restore 4.7.5 Factory DefaultsTo upgrade the devices firmware, follow these instructions To restore the devices configuration, follow these instructions 4.7.7 Reboot2. Wrong process will lead the device unmanaged 4.7.9 System Log 4.7.8 PasswordFigure 4-31 System Log Appendix A Application Example 3 Right-click the wireless connection icon “” on the screen of the PC and then select View Available Wireless Networks TL-WA730RE 150Mbps Wireless Range Extender User Guide Default Value Appendix B Factory DefaultsCommon Default Settings Wireless1. No LEDs are lit on the access point Appendix C Troubleshooting2. The LAN LED is not lit General Appendix D SpecificationsPhysical and Environment Appendix E Glossary TL-WA730RE 150Mbps Wireless Range Extender User Guide

Related manuals

Manual 68 pages 59.99 Kb