TP-Link TL-WA730RE manual Fcc Statement, CE Mark Warning, FCC RF Radiation Exposure Statement

Page 3
FCC STATEMENT

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3
Contents Rev 1.0.0 TL-WA730RE 150Mbps Wireless Range ExtenderAll rights reserved COPYRIGHT & TRADEMARKSFCC STATEMENT CE Mark WarningFCC RF Radiation Exposure Statement Reason/remark National restrictionsCountry RestrictionETSI EN 301 489-1 V1.8.12008& ETSI EN 301 489-17 EN60950-12006 DECLARATION OF CONFORMITYProduct Description 150Mbps Wireless Range Extender ETSI EN 300 328 V1.7.1Chapter 3 Quick Installation Guide CONTENTSPackage Contents Hardware InstallationAppendix A Application Example Appendix B Factory DefaultsAppendix C Troubleshooting Appendix D SpecificationsConventions Package ContentsChapter3 Quick Installation Guide Overview of This GuidePackage Contents Chapter 2 Hardware Installationyour PC Introduces how to set your AP to be a DHCP server so4.6 DHCP that the AP will automatically assign an IP address for1.1 Product Overview 1.2 Main FeaturesFeatures Chapter 1 IntroductionLED Explanation 1.3 Appearance1.3.1 The Front Panel TL-WA730RE 150Mbps Wireless Range Extender User GuideEnsure the Range Extender is powered on before it restarts completely 1.3.2 The Rear Panel2.2 Basic Requirements Chapter 2 Hardware Installation2.3 Connecting the Device 2.1 Before You Begin1. Connect the Cable or DSL modem to a Router 3.1 Configure the PC Chapter 3 Quick Installation GuideTL-WA730RE 1 Select Use the following IP address 3.2 Quick Setup Figure 3-9 Quick Setup Figure 3-11 AP List Figure 3-12 Quick Setup - Range Extender ModeB. When you choose Access Point, take the following steps TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.1 Status Chapter 4 Configure the Device4.3 QSS 4.2 Quick SetupMethod One To add a new deviceFigure 4-3 Add A New Device Next TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.4 Network 4.5.1 Wireless Settings 4.5 WirelessTL-WA730RE 150Mbps Wireless Range Extender User Guide TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.2 Wireless Security 1 Range Extender ¾ WPA-PSK/ WPA2-PSK - Select WPA based on pre-shared key 2 Access Point TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.3 Wireless MAC Filtering To modify or delete an existing entry To set up an entry, follow these instructions4.5.4 Wireless Advanced 4.5.5 Throughput Monitor 4.5.6 Wireless Statistics This page will be refreshed automatically every 5 seconds 4.6 DHCP4.6.1 DHCP Settings 4.6.3 Address Reservation 4.6.2 DHCP Clients ListTo modify A Reserved IP address 4.7 System ToolsThe changes wont take effect until the device reboots To Reserve IP addresses4.7.1 SNMP 4.7.2 Diagnostic Figure 4-23 Diagnostic 1 Only one user can use this tool at one time 4.7.3 Ping Watch Dog4.7.4 Firmware Upgrade 4.7.5 Factory Defaults 4.7.6 Backup & RestoreTo upgrade the devices firmware, follow these instructions 4.7.7 Reboot To restore the devices configuration, follow these instructions2. Wrong process will lead the device unmanaged 4.7.9 System Log 4.7.8 PasswordFigure 4-31 System Log Appendix A Application Example 3 Right-click the wireless connection icon “” on the screen of the PC and then select View Available Wireless Networks TL-WA730RE 150Mbps Wireless Range Extender User Guide Wireless Appendix B Factory DefaultsDefault Value Common Default SettingsAppendix C Troubleshooting 1. No LEDs are lit on the access point2. The LAN LED is not lit Appendix D Specifications GeneralPhysical and Environment Appendix E Glossary TL-WA730RE 150Mbps Wireless Range Extender User Guide
Related manuals
Manual 68 pages 59.99 Kb