Display, Handsfree function, Message Waiting indicator

English

Operation

The display

In standby mode (handset down, no dial tone) the display will show the date and time, number of new and total number of calls stored in the Caller ID memory. Immediately following the connection of a call, a call timer will be shown on the display. The timer is a simple way to help you keep track of how long the call lasts.

Handsfree function

1.Press s. The handsfree function (speaker) will be activated and the LED indicator next to the button will illuminate.

2.Dial the telephone number. To adjust the speaker volume, use the volume control on the side.

3.Speak towards the microphone located on the front edge of the telephone.

4.Press s to terminate the call.

If you wish, you can switch between handset mode and handsfree mode during the call.

Please note!

Please remember that in handsfree mode it is only possible for one person at a time to talk. The switch-over between speaker and microphone is automatic and dependent on the sound level of the incoming call and the microphone respectively. It is therefore essential that there are no loud noises, e.g. music, in the immediate vicinity of the telephone, as this will disrupt the handsfree function.

Message Waiting indicator

Some PBX systems use a function called Message Waiting. The telephone can be made to indicate this by having the Indicator flash in standby mode.

There is a switch located underneath the telephone for this (MW).

This function operates differently depending on the PBX in question. Please contact the system controller for more information. The following four alternatives are available: LED+, LED-, ringer indicator ( ) and high DC voltage (HV).

When the telephone is used in systems without telephone exchanges, the ringer indicator ( ) should be selected.

EN 3