BT 1100 Executive manual Setting up, Connect the power supply and switch on

Page 10

Setting up

Please note that your handset is already registered to the base station.

Plan the location.

Situate your product close enough to the telephone and mains power sockets so that the cables will reach.

Make sure it is at least 1 metre away from other electrical products to avoid interference.

Do not situate the product in the bathroom or other humid areas.

1Connect the power supply and switch on.

Thread the power supply cable and line cord through the square hole in the plinth before fixing to the base.

Plug the power supply cable into the socket on the underside of your base. The power cable connector and socket are coloured red.

WARNING

Please take care that the power supply and telephone line cord are connected to the correct sockets as incorrect placement could damage your equipment.

Once connected, put the plinth back on the base to prevent it from rocking on the table.

There are two positions for the plinth when joining it to the base both can be used for desk mounting and one of them for wall mounting (see wall mounting on page 27).

Plug the power adaptor into the wall socket and switch on. When the power is switched on, the button on your base will light up.

WARNING

Do not connect the telephone line cord to the phone socket until your handset is fully charged. This will prevent the risk of the phone being answered before the battery is charged. Answering the phone before the battery is fully charged may prevent it from reaching its optimum capacity.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents User Guide At a glance Base Setting up Using the telephone This guideMenu Structure Menu Structure Key features Unpacking your BT On-Air 1100 Executive IntroductionFor your records Safety information GeneralSetting up Connect the power supply and switch onBattery low warning Connect the telephone line cord after charging your handsetUsing the telephone Making and ending callsHandsfree RedialName and number directory To switch secrecy on/offSecrecy To dial a number from the directoryTransferring calls Internal callsPaging handsets To edit and delete directory numbersTo use your handset when the keyguard is on To switch keyguard off To switch keyguard onKeyguard To turn the alarm off Alarm clockTo set the alarm AlarmCaller Display TimerRinging and Beeps To enter the calls list To adjust ringer melody and volumeCalls list To dial a number in the calls listTo set the time Keypad beeps and tonesTo set the date To change your System Code Base settingsTo change base station priority Using additional handsets and bases Using additional handsets and basesRegistering additional handsets To de-register a handset from the base DE-REGISTERHelpline General information GuaranteeTechnical information To set the external line access code Switchboard compatibilitySwitchboard External Line Access Code Base SettingsPrefix Wall mounting Wall Plug ScrewPage Offices in Europe, North America, Japan and Asia Pacific
Top Page Image Contents