Diverse 3010 Executive 22/3/01 12:02 pm Page 8
Diverse 3010 Executive – Edition 4 – 22 November ’00 - 3509
Note | If e.g Base 1, flashes continuously |
SETTING UP
Under ideal conditions, the handset batteries should give about 10 hours talktime or 100 hours standby on a single charge. However, new NiCad batteries do not reach their full capacity until they have been in normal use for several days.
Please note that the lifespan of NiCad rechargeable batteries depends on how heavily they are used. However, over time, their capacity to recharge will begin to diminish and they will eventually need replacing.
Battery low warning
An LCD on the handset display shows the current state of the charge. When the batteries are almost flat a beep sounds and the display shows the empty battery symbol. Displays showing the various states of charge are shown below:
Batteries fully charged
Batteries at 66%
Batteries at 33%
It means the handset is either out of range or is not registered with the base station. To register, follow the steps on page 42. All additional handsets you purchase will need to be individually registered with the base station before they will work with the Diverse 3010 Executive.
The base number may also flash after a power failure. Provided the handset has been registered with the base, the base number will stop flashing after a while indicating the handset has automatically
Note
If you go out of range of a base station for a long time while your handset is switched ON, it may take more than 20 minutes to ‘find’ the base station again when you come back within range. However, by simply switching the handset OFF for a moment, then ON again, it will find the base station within a few seconds.
Batteries empty
8