BT 7163 manual Battery low warning, Battery guard tab, Battery performance, Telephone, Line cord

BT Glide – Edition 07 – 20.01.06 – 7163

	Getting started	7
2. Remove the battery guard	Battery low warning
tab from the bottom of the	The handset battery symbol has
handset.	only one red bar left and you
	will hear a warning beep every
	5 minutes. Start recharging
	your handset right away or the
	handset will shut down.
Battery guard tab	Battery low
	Battery full
	When charging, the battery
	symbol is blue and it scrolls.

3.Place the handset on the base to charge for at least 24 hours. The charging light comes on. The handset

is pre-registered to the base as BT Glide. The screen	When you place a handset with
	a completely flat battery on to
shows the standby display.
	the base, the charge light will
The charging light stays on while the handset is being	come on but the handset will
	not start. You must wait up to
charged. Once fully charged the light will go off.	10 minutes before the battery
	has enough charge for the
4. After 24 hours charging, plug one end of the	handset to start.
telephone line cord into the socket marked
on the base and the other end into the telephone	Battery performance
line wall socket.	Running the battery right down
	at least once a week will help it
Only use the telephone line cord supplied.	last as long as possible.
	On a full charge, your BT Glide
	handset gives you up to
	7 hours talk time or up to
	72 hours standby.
	The charge capacity of a
	rechargeable battery will
Telephone	reduce with time as it wears
	out, giving the handset less
line cord	talk/standby time. Eventually it
	will need to be replaced.
	The battery and handset may
	become warm during charging.
	This is normal.
Route the cable through the channel on the base.

If you experience any problems, please call the Helpline on 0870 605 8047