Cisco Systems 7970G manual Message Description Possible Explanation and Action

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone

Status Menu

Table 7-2	Status Messages on the Cisco Unified IP Phones 7970G/7971G-GE
Message		Description	Possible Explanation and Action
BootP server used		The phone obtained its IP	None. This message is informational only.
		address from a BootP server
		rather than a DHCP server.
CFG file not found		The name-based and default	The configuration file for a phone is created
		configuration file was not	when the phone is added to the Cisco
		found on the TFTP Server.	Unified CallManager database. If the phone
			has not been added to the Cisco
			Unified CallManager database, the TFTP
			server generates a CFG File Not Found
			response.
			• Phone is not registered with Cisco
			Unified CallManager.
			You must manually add the phone to
			Cisco Unified CallManager if you are not
			allowing phones to auto-register. See the
			“Adding Phones with Cisco Unified
			CallManager Administration” section on
			page 2-16for details.
			• If you are using DHCP, verify that the
			DHCP server is pointing to the correct
			TFTP server.
			• If you are using static IP addresses, check
			configuration of the TFTP server. See the
			“Network Configuration Menu” section
			on page 4-7for details on assigning a
			TFTP server.
CFG TFTP Size Error		The configuration file is too	Power cycle the phone.
		large for file system on the
		phone.

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones

OL-11524-01 7-5