CHAPTER 7 (CONTINUED)
CHANNEL SETTINGS
The DIALOGUE RC and Remote Transmitter use radio signals to communicate with each other. For the Remote Transmitter to activate the DIALOGUE RC, they both have to be on the same "channel." A "DIP Switch" is used for channel selection.
Your phone and remote have been preset at the factory to a standard channel setting. Under normal operating condi- tions, there is no adjustment necessary.
ON |
1 2 3 4 5 6 7 8 |
ON
1 2 3 4 5 6 7 8
S |
|
|
|
|
E |
|
|
|
|
T |
|
|
| |
T |
| |||
| O | |||
|
|
| M | |
|
|
|
| A |
|
|
|
| T |
|
|
|
| C |
|
|
|
| H |
|
| A | X | E |
| C |
| ||
T |
|
| ||
|
|
| ||
|
|
|
| |
L |
|
|
|
|
Y |
|
|
|
|
If your system encounters interference and repeatedly activates by itself for no obvious reasons, it may be necessary to change DIP Switch settings on the DIALOGUE RC and Remote Transmitter.
1.Unscrew bottom of the Remote Transmitter.
2.Locate DIP Switches on Remote Transmitter and on bottom of
DIALOGUE RC.
3.Using a ball point pen, change the settings on all switch positions to match exactly on both DIALOGUE RC and Remote Transmitter.
4.Replace remote cover and test.
(Remove cover to expose switch)
Figure 24 – Channel setup
13