Ameriphone RC-100 Chapter Installation, Battery included with RC-200 Speakerphone, Connections

Page 6
Figure 3 – battery compartment

CHAPTER 4

INSTALLATION

A. Battery (included with RC–200)

Speakerphone

1. Six "AA" size, Nickel Cadmium (NiCad) recharge- able batteries are

used for back–up during a power out-

age (Fig 3). They power the DIA- LOGUE RC for approximately

3 hours. DO NOT USE ALKALINE BATTERIES, they will damage your equipment.

Remote Transmitter

2.Install the "23A" size 12V alkaline cigarette lighter battery in the Remote Transmitter (included) as shown (Fig 4). With normal usage, it lasts 6–12 months. If the power indicator light is faint or does not come on when the button is pressed, replace the battery. The Remote Transmitter has an operating range of up to 40 feet.

 

Power

 

indicator

 

Jack for

 

accessory

 

switch

 

Thread both

Battery

ends of necklace

through hole and

compartment

tie a small knot.

 

(optional)

Figure 4 – Remote Transmitter

B. Connections

Figure 5 – Connection of phone line and AC adapter

1.Connect the phone line and AC adapter as shown.

2.Set the tone/pulse selector (T/P) to T if you have touch tone service, set to P if you have pulse dialing (rotary). (See Fig 2)

The DIALOGUE RC can be placed on a desk, or mounted on the wall. Do not put the DIALOGUE RC on or next to metal surfaces, computers, televisions, radios, microwaves, or other electrical equipment that can cause inter- ference to the wireless signal from the Remote Transmitter.

C. Setting up your RC

The DIALOGUE RC comes with the following operating settings from the factory:

1.Scan rate is 5 seconds per memory location.

2.Voice activated answering (RC–200 only) is off.

3.Unanswered call indicator is on.

4.Voice mail indicator (RC–200 only) is off.

5.Tone/pulse switch set to Tone.

6.Ring volume set to Hi.

7."0" (operator) is programmed into first memory location of M1.

8.Remote flash switch (RC–200 only) is off.

4

Image 6
Contents Rcdialogue RC Important Safety Instructions Table of Contents Package Checklist Chapter Introduction714 714 897-4703 Fax Tone/pulse selector underneath Chapter Features IdentificationMicrophone Scan button Volume control Memory Program button Mute button Flash/Pause button On/Off button Redial buttonSetting up your RC Chapter InstallationBattery included with RC-200 Speakerphone Remote TransmitterChapter Setting the Scan FunctionTo turn the Remote Flash feature on or off RC-200 only To turn Voice Activation on or off RC-200 onlyProgramming numbers into memory Chapter OperationMaking phone calls Dialing on the keypad To program a number into memoryAnswering phone calls Using the keypad Dialing by using the Scan buttonDialing using the Remote Transmitter Using the Remote TransmitterVoice Activated answering Dialogue RC-200 only Other Operations Redialing the last number dialedDialogue RC turns on Flash button Pillow Switch Chapter Optional AccessoriesAIR Switch Lapel MicrophoneQuick Start Guide Summary Press Remote Transmitter to hang up Symptom Cause and Remedy Sensitivity AdjustmentChapter Case of Difficulty Channel Settings Dialogue RCChapter Maintenance FCC Information Chapter Warranty Contact US Chapter Feature SummaryOr accessory switch Back-up battery Provided Index