CHAPTER 4 (CONTINUED)
You may set up the DIALOGUE RC in the following manner to better suit your needs.
Setting the Scan Function
If you have DIALOGUE RC–100:
Only the first six numbers in the memory are automatically scanned. It stops at each mem- ory location for 5 seconds to allow you to
3.Press SCAN button.
| V O L | M U T E |
P R O G | SCAN | H E A D S E T |
|
| M I C |
Figure 8
select.
To turn scan function off (or on):
1.Press PROGRAM.
2.Press 0 on the keypad to turn it off; or press 1 key on the keypad to turn it on.
3.Press SCAN button.
If you have DIALOGUE
All memory locations with numbers stored are automatically scanned. The scan rate deter- mines how long the DIALOGUE
To turn scan function on or off:
To turn Voice Activation on (or off) (RC–200 only):
1.Press PROGRAM.
2.Press MUTE button twice. The MUTE indicator flashes once, and the RC- 200 emits four beeps to confirm that Voice Activation has been turned on.
3.To turn it off, repeat steps 1 and 2. This command is confirmed by four beeps.
To turn the Unanswered Call Indicator
1. | Press PROGRAM. |
2. | Press HEADSET button twice. |
| (Emits four beeps to confirm command). |
1.Press
PROGRAM.
| V O L | M U T |
PROG | S C A N | H E AD |
|
| M I C |
Figure 6
3. To turn it on again, repeat steps 1 |
and 2, and the HEADSET indicator |
flashes once. |
To turn the Voice Mail Indicator feature on (or off),
2.Using chart, select length of pause and press the corresponding digit on keypad.
| Length of Pause at Each |
Key Entered | Location in Seconds |
Scan Function Off
5
4.5
4
3.5
3
2.5
2
1.5
1
Figure 7
1.Press PROGRAM.
2.Press FLASH/PAUSE button twice.
3.To turn it off again, repeat steps 1 and 2, and the FLASH/PAUSE indicator does not flash.
To turn the Remote Flash feature on (or off) (RC–200 only):
1.Slide remote flash switch to "On" (or "Off") position.
5