Install a 9V alkaline transistor radio battery. Be sure to install the battery polarity correctly by observing the drawing on the inside of the compart- ment. Replace the battery door and the screw.
3.Plug one end of the coiled handset cord into the handset’s jack and the other end into the base handset jack.
4.For wall mounting, the handset must be retained securely in the cradle. The handset guide must be changed from the desk position to the wall position. To do this, pull the handset guide out and rotate it 180. It will now protrude slightly, providing a tab for the handset to rest on.
5.Connect the a. c. power adapter to the power jack on the NSQ412. Do not connect the adapter to the electri- cal outlet at this time. Route the adapter cord through the A. C. Adapter Hook on the station’s back.
If you are installing the NSQ412 to screws, skip down to step 12.
6.If you install the NSQ412 to the mounting studs of a telephone wall jack, lines 1 and 2 must be terminat- ed to it. Lines 3 and 4 (if used) must be terminated to a different jack.
7.Connect the short
Lines 3/4 A.C. Adapter
8.Hold the station close to the tele- phone wall jack and plug the short line cord into it. Align the wall jack studs with the wall mounting holes on the NSQ412’s back.
9.Push the NSQ412 onto the studs and firmly pull downward (toward the floor), locking the station onto the wall jack.
10.Connect the other telephone jack with lines 3 and 4 to the NSQ412 jack L3/L4 using one long
11.Connect the a. c. adapter to an elec- trical outlet. The station will initialize for about 7 seconds, then be ready for use and programming.
61/2
NSQ412