Verizon NSQ412 owner manual Ringer Status, Intercom Tone Status, Station Initialization

In sync with CO ring signal (it will choose one pattern if more than 1 CO Line is ringing at the same time)

0.250S on, 0.250S off, 0.250S on, 1.250S off, repeatedly

1S on, 1S off, repeatedly

Continuously

0.250S on

0.250S on, 0.250S off, 0.250S on, 0.250S off

Ringer Status

The station’s ringer will indicate the status as shown in the fol- lowing chart

Ring Cadence

CO ring

Intercom ring

Transfer ring

ID Error ring

Single Beep

Double Beep

Intercom Tone Status

The station’s intercom tones are shown below:

Intercom Tones

dial tone	continuous
busy tone	0.5S on, 0.5S off, repeatedly
DND tone	0.25S on, 0.25S off, repeatedly
ring back tone	1S on, 1S off, repeatedly

Station Initialization

The telephone will perform initialization during the first seven seconds that a. c. power is applied. The LCD will display:

I n i t i a l i z i n g . .

During initialization, the telephone will perform self-diagnostics and determine if other system telephones are connected. It will indicate if its station number is already used by another station by continuous ringing. If the telephone has the factory default settings, the LCD will display:

	0 1 / 0 1		0 1 : 0 0 A
	E X T 1 1 P o w e r F a i l
	p r e s s P R O G t o
	s e t u p y o u r p h o n e
"01/01 01:00A"		The default time.
"EXT 11"		The default station number.
"PowerFail"		The phone was just turned on. (This
		prompt will cancel if any key is
		pressed or the phone goes off-hook.)
"press PROG to		This is displayed if the phone is with
setup your phone"			factory default settings when the a. c.
		adapter is plugged in. (This prompt
		will be canceled if the [PROGRAM] is
		pressed.)

NSQ412 Four-Line Caller ID Telephone Owner’s Manual 17