12.Follow these steps if the station will be installed on screws securely fas- tened to the wall. If telephone lines 1 and 2 are on one jack and tele phone lines 3 and 4 on another jack see the following connection draw-
ing. Otherwise go to step 13.
Lines 3/4 | Lines 1/2 | A.C. Power |
Connect telephone jack 1 to the NSQ412 L1/L2 jack using one of the
13.If telephone lines 1, 2, 3 and 4 are all on separate jacks, two adapters and extra telephone line cords are necessary (not included with the telephone). See the following con- nection drawing.
The adapters will convert two sepa- rate telephone jacks into a single one. Connect telephone line 1 into the adapter. Connect telephone line 2 into the adapter. Connect the adapter output jack into the NSQ412 L1/L2 jack using one of the
ductor telephone line cords supplied with the telephone. Repeat this process using the sec- ond adapter for tele phone lines 3 and 4. Connect the output of the second adapter jack
to the NSQ412 L3/L4 jack using the other telephone line cord supplied with the telephone.
Line 1 | Line 2 |
2 LINE ADAPTER
Line 3 | Line 4 |
2 LINE ADAPTER
14.Using the supplied screw template, install the screws into the wall. Be sure to use anchors to ensure a secure mounting. Leave the screws protruding from the wall 3/16”.
15.Hold the station close to the screws and align them with the wall mount- ing holes on the NSQ412’s back.
Push the station onto the screws and firmly pull downward (towards the floor), locking the station to the wall.
16.Connect the a. c. adapter to an elec- trical outlet. The station will initialize for about 7 seconds, then be ready for use.
The telephone has the program- ming set to the most common selections. See the Quick
Reference Card to begin using it immediately. Refer to the Programming section of this manual for customizing the sta- tion’s operation and the Feature Sections for advanced operation and use.
NSQ412