RUIM Usage (RUIM Models Only)
Your service provider may require you to install a RUIM (Removable User Identity Module) in your SX6P for it to operate normally (see RUIM Card Installation on page 1 for details). Without a RUIM, these SX6P models will reject incoming calls and allow only emergency outgoing calls.
Once a
Starting Your SX6P with a RUIM PIN
If your RUIM requires a PIN, follow these steps:
1.Power on your SX6P.
2.The SX6P will prompt you to enter your PIN. Enter the PIN for your RUIM, then press 
[Store].
3.If you enter the wrong PIN, the SX6P will display an error message and ask you to reenter the PIN.
4.Entering an incorrect PIN three times will cause the SX6P to block the inserted RUIM. If your RUIM is blocked due to incorrect PIN use, it will prompt you to enter the unblocking code. You must contact your service provider to obtain this unblocking code. Do not guess at the block code or use your own PIN to attempt to unblock the SX6P; entering wrong codes will eventually cause the RUIM to become permanently blocked.
5.If you are unable to enter the correct PIN for the inserted RUIM, the SX6P will not operate normally. It will reject incoming calls and permit only emergency outgoing calls.
Starting Your SX6P if Your RUIM Requires No PIN
Power on your SX6P. No additional steps are necessary.
Starting Your SX6P if it is Bonded to a RUIM
An SX6P may be bonded to a specific RUIM. Once it has been bonded, the SX6P will not operate normally with any other RUIM installed in it. It will reject incoming calls and permit only emergency outgoing calls. The same holds true for any other SX6P that the bonded RUIM is installed into: it will not operate normally.
To start a bonded SX6P, power it on. No additional steps are necessary if the correct RUIM is inserted into the SX6P.
If you want to bond an SX6P to an RUIM, contact your service provider.
Phonecell® SX6P CDMA | 5 | User Manual |