CALLER ID OPERATION (CONT.)
TROUBLESHOOTING
Caller ID Erase
To Erase a Single Call
1.Press the “” or “” button to review the Caller ID records you received.
2.Press DEL button to erase the call displayed; the display will show “ERASE ?” on the bottom line.
3.Press DEL button again; the Caller ID will be erased and the display will show the next message.
NOTE:
If the current message displayed is the last message, then the display will return to standby mode.
VIP Calls
Your telephone allows you to create VIP call records. When a VIP call is received, 4 beeps will sound between rings, to alert you this is a VIP call.
To Create a VIP Call record :
1.Press the “” or “” button to select the Caller ID which you want to assign a VIP ringer.
2.Press and hold the CALLS button for
2seconds. The “VIP” icon is displayed.
NOTE:
4 beeps will also sound when the incoming VIP call is a Call Waiting call.
If your telephone is not performing to your expectations, please try these simple steps :
Problem |
| Suggestion |
|
|
|
“Charging” won’t show on | • | Make sure the AC Adapter is plugged into |
when handset is placed in |
| the base unit and wall outlet. |
• | Make sure the wall outlet is functioning. | |
base unit. | • | Make sure the handset is properly seated in |
|
| the base unit. |
| • | Make sure the rechargeable battery pack is |
|
| properly placed in the handset. |
| • Make sure that the charging contacts on | |
|
| the handset and on the base unit are clean. |
|
|
|
No dial tone. | • | Charge the handset for 10 hours before |
|
| initial use. |
| • Place the handset back into cradle for 5 | |
|
| seconds. |
| • | Make sure the handset is fully charged. |
|
| The base display should show “CHARGING” |
|
| when the handset is in the cradle. |
|
|
|
Can’t make outgoing calls. | • | Make sure the Tone/Pulse switch is set to |
To Erase All Calls
1.Press the “” or “” button to review the Caller ID records received before erasing all calls.
2.While the display is in standby mode, press and hold the DEL button for 2 seconds. The display will show “ERASE ALL ?” on the bottom line.
3.Press the DEL button; all VIEWED calls will be erased.
NOTE:
1.If there are messages that have not been reviewed, the “Erase All Calls” function cannot be performed.
2.VIP calls will not be erased when you erase all calls.
22
To Remove a VIP Call :
1.Press the “” or “” to select the call you have marked “VIP”.
2.Press and hold the CALLS button for
2seconds. The “VIP” icon will disappear.
|
| the correct setting. If set to the Tone mode, | ||
|
| switch to Pulse. You may have pulse dialing | ||
|
| service. | ||
|
|
|
|
|
Handset doesn’t ring. | • | Make sure the Ringer On/Off switch on the | ||
|
| side of the handset is set to the “On” | ||
|
| position. | ||
| • | Rechargeable battery pack may be weak or | ||
|
| not fully charged. Charge the battery pack | ||
|
| for | ||
| • Make sure the base antenna is in the | |||
|
| upright position. | ||
| • | The handset may be too far away from the | ||
|
| base unit. | ||
| • | Make sure the AC adaptor is plugged into | ||
|
| the base unit and wall outlet. | ||
| • | Make sure the wall outlet is functioning. | ||
| • There may be too many telephones | |||
|
| installed on the same line. Contact your | ||
|
| local telephone company to determine the | ||
|
| maximum number of extensions for your | ||
|
| calling area. | ||
| • Place the handset back into cradle for 5 | |||
|
| seconds. | ||
|
|
|
|
|
|
|
| 23 |
|
|
|
|
|
|