VTech VT 9152 Your Caller Fades in and OUT, YOU Hear Other Calls While Using Your Phone

Page 20

ADDITIONAL INFORMATION

IN CASE OF DIFFICULTY

YOUR CALLER FADES IN AND OUT.

•You may be nearly out of range. Move closer, or relocate the base.

YOU HEAR OTHER CALLS WHILE USING YOUR PHONE.

•Press CHAN key to switch to another channel.

•Disconnect your base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.

YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUT- TONS WORK.

•Make sure the power cord is plugged in.

•Your base unit and handset may not be operating on the same channel. Place the handset in the cradle for a few moments to reset the channel.

YOUR ANSWERING SYSTEM IS NOT RECORDING MESSAGES

•Make sure your Answering System is turned on. See TURNING YOUR ANSWERING SYSTEM ON/OFF.

•Your Answering System may be in ANNOUNCE ONLY mode. See SET ANNOUNCE ONLY for steps to return to normal (record messages) operation.

THE ANSWER ON/OFF LIGHT ON THE BASE UNIT IS BLINKING

•This indicates that the Day and Time need to be set. See SET DAY & TIME for more information.

COMMON CURE FOR ELECTRONIC EQUIPMENT

Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the handset in the cradle to re-initialize the unit. If it still does not seem to respond, perform the following steps (in the order listed):

1.Disconnect the power to the base.

2.Disconnect (remove) the handset battery.

3.Wait a few minutes.

4.Connect power to the base.

5.Install the handset battery pack.

6.Put the handset in the base to re-initialize. If the handset has not been recently charged, allow 16 hours before use.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Table of Contents Additional Information Important Safety Instructions Introduction Parts Check ListGetting Started Recharging the Battery PackReplacing the Handset Batteries Getting Started Setting UP Your VT Wall Mounting Handset Features and Keys Getting Started Base Unit Features and Keys Getting Started Basic Operation Using Your VT 9152 Cordless Telephone Basic Operation Basic Operation Answering System Operation IntroductionUSE the VT 9152 Handset to Program Your Answering System Call Screening from Base UnitHandset Layout for Answering System Operation KEY FunctionAnswering System Setup SET Base Ringer SET Number of RingsChecking DAY and Time Recording a MemoPlayback of GREETINGS, Messages and Memos To Hear Your Outgoing GreetingRemote Commands Remote Operation of Your VT 9152 Answering SystemOperation Headset OperationBelt Clip Handset does not Ring When YOU Receive a Call Case of DifficultyPhone DOESN’T Work AT ALL No Dial ToneYOU Hear Other Calls While Using Your Phone Your Caller Fades in and OUTYour Answering System is not Recording Messages Answer ON/OFF Light on the Base Unit is BlinkingLimited Warranty Statement What does this limited warranty cover?How long is the limited warranty period? What is not covered by this limited warranty?How do you get warranty service? Other limitationsIC Industry Canada FCC and IC RegulationsFCC Part Rbrc R Seal Maintenance Taking Care OfyourtelephoneTechnical Specifications Page Issued
Top Page Image Contents