VTech VT 9152 Replacing the Handset Batteries, Getting Started, Recharging the Battery Pack

Page 5

REPLACING THE HANDSET BATTERIES

1. Slide the battery cover off by gently pressing on the recessed area with a downward motion.

2. Unplug and remove the old battery pack. Don't put the old battery pack in a trash compactor or a fire - it could burst.

3. Plug in the replacement battery pack. Place the battery pack in the compartment with the battery cord resting on top of it.

4. Replace the battery cover by sliding it into place.

5. The new battery pack must be charged before using your telephone. Place the handset in the cradle of the base unit to allow it to charge for 16 hours.

CAUTION: To reduce the risk of fire or injury, read and follow these instructions:

1.Use only VTECH battery pack.

2.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

3.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

4.Do not dispose of the battery in a fire. The cell may explode.

Recharging the Battery Pack

Your VT 9152 provides both audible and visual alerts when the battery pack is low and requires charging. Return the Handset to the Base cradle when:

1.The IN USE/LOW BATT LED is slowly flashing; and/or

2.You hear a double beep while you’re on a call or when you press PHONE/FLASH to make or answer a call.

When fully charged, you will experience up to 5 hours of continuous talk, or up to 6 days of standby (off the cradle, but not in use).

GETTING STARTED

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Table of Contents Additional Information Important Safety Instructions Parts Check List IntroductionGetting Started Recharging the Battery PackReplacing the Handset Batteries Getting Started Setting UP Your VT Wall Mounting Handset Features and Keys Getting Started Base Unit Features and Keys Getting Started Basic Operation Using Your VT 9152 Cordless Telephone Basic Operation Introduction Basic Operation Answering System OperationUSE the VT 9152 Handset to Program Your Answering System Call Screening from Base UnitKEY Function Handset Layout for Answering System OperationAnswering System Setup SET Number of Rings SET Base RingerChecking DAY and Time Recording a MemoTo Hear Your Outgoing Greeting Playback of GREETINGS, Messages and MemosRemote Operation of Your VT 9152 Answering System Remote CommandsOperation Headset OperationBelt Clip Case of Difficulty Handset does not Ring When YOU Receive a CallPhone DOESN’T Work AT ALL No Dial ToneYour Caller Fades in and OUT YOU Hear Other Calls While Using Your PhoneYour Answering System is not Recording Messages Answer ON/OFF Light on the Base Unit is BlinkingWhat does this limited warranty cover? Limited Warranty StatementHow long is the limited warranty period? What is not covered by this limited warranty?Other limitations How do you get warranty service?IC Industry Canada FCC and IC RegulationsFCC Part Rbrc R Seal Taking Care Ofyourtelephone MaintenanceTechnical Specifications Page Issued
Top Page Image Contents