VTech I6768, I6787, i6777 important safety instructions CONNECTING... is

Troubleshooting

Problem	Suggestion
CONNECTING... is	• De-register all handsets and then register the handsets again (only one handset can be
shown in the handset	registered at a time).
display window. Why	To de-register all handsets:
don’t I get a dial tone	1. Press and hold FIND HANDSET on the main telephone base for four seconds.
when I try to use this	2. When the IN USE light starts to flash, release the FIND HANDSET button.
telephone?	3. Press and release FIND HANDSET again. The IN USE light will turn off and in a few seconds,
	all handsets will be de-registered.
	4. All handsets will show NOT REGISTERED.
	To register a handset (register one handset at a time):

1.Place the handset in the telephone base or a charger that is connected to a power outlet. If PRESS FIND HNDST 4 SEC ON BASE does not appear on the screen after a few seconds, lift up the handset and place it in the telephone base or charger again.

2.On the telephone base, press and hold FIND HANDSET for four seconds. Release FIND HANDSET once the IN USE light comes on.

After a while, the handset will emit a series of tones. The newly registered handset will be assigned the lowest handset number not previously assigned to another system handset when successfully registered. Repeat steps 1 and 2 if the handset is not successfully registered to the telephone base within two minutes.

Repeat the registration procedure for each system handset.

48 www.vtechphones.com