VTech VT 9122 Installation of Battery Pack in Handset, Follow the Instructions

Page 6

GETTING STARTED

INSTALLATION OF BATTERY PACK IN HANDSET

The Handset of your VT 9122 is powered by a rechargeable battery pack. It charges automati- cally whenever the Handset is in the Base Unit. The battery pack needs charging when:

The low battery icon is displayed:

• A beep will be generated every 7 seconds in TALK mode only. Handset will return to standby if this condition lasts for 3.5 minutes.

To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGE indica- tor will light to show the Handset is seated properly and the battery pack is charging. It is recommended that the battery pack be charged for at least 16 hours initially. Afterwards, 8 hours of maintenance charging should be sufficient.

To replace the battery pack, follow the steps below:

1.Remove the battery case cover by pressing on the ridged lines and sliding downward.

2.Discard the old battery pack by pulling firmly on the battery cords. Don’t put the old battery pack in a trash compactor or a fire - it could burst. Please recycle.

3.Snap in the new battery pack. Insert the battery plug into the socket, aligning the two holes in the plug with the socket pins.

4. Replace the battery case cover by sliding the cover upwards.

5.Place the Handset in the cradle of the Base Unit to allow it to charge for 16 hours.

CAUTION: To Reduce the Risk of Fire or Injury, Read and

Follow the Instructions

IMPORTANT:

Do not dispose of this battery pack into household garbage. For information on recycling or proper disposal, consult your local solid waste collection or disposal organization.

1. Use only VTech rechargeable battery pack, or equivalent.

2.Do not dispose of the battery pack in a fire. The cell may explode.

3.Do not open or mutilate the battery pack. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may

be toxic if swallowed.

4. Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery pack or conductor may overheat and cause burns.

To purchase replacement battery packs, call VTech at 1-800-595-9511.

6

Image 6
Contents Table of Contents Important Safety Instructions Parts Check List Handset Layout Base Layout Installation of Battery Pack in Handset Follow the InstructionsProgram Local Area Code Setting UP Your VTLanguage Selection Ringer SelectionWall Mounting Handset Display Making Calls Volume ControlBasic Operation Channel ChangingFlash Using RedialAnswering Calls HoldCaller ID/CALL Waiting ID Phone Book Dialing from Caller IDStoring a Name and Number Into the Phone Book Reviewing and Dialing from the Phone Book Deleting Phone Book RecordsMessage Waiting Installation OperationBelt Clip Maintenance Case of Difficulty Phone DOESN’T Work AT ALLNo Dial Tone Your Caller Fades in and OUT Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Common Cure for Electronic EquipmentWarranty Statement Rbrc Seal FCC & IC Regulations FCC PartIC Industry Canada Technical Specifications Issued