VTech IP8300 Before dialing Check the signal icon, Strong network coverage, Less background noise

Troubleshooting

Problem	Suggestion
	�� Test a working telephone at the telephone jack. If another telephone has the same problem,
	the problem is in the telephone jack. Contact your local telephone company (charges may
	apply).
	�� The telephone line cord might be malfunctioning. Try installing a new telephone line cord.
	�� Re-install the battery and place the cordless handset in the charger.
	�� Wait for the cordless handset to synchronize with the telephone base. Allow up to one minute
	for this to take place.
I cannot dial out.	�� First, try all the above suggestions.
	�� Make sure there is a dial tone before dialing. It is normal if the cordless handset takes a second
	or two to synchronize with the telephone before producing a dial tone. Wait an extra second
	before dialing.
	�� Check the signal icon	at the top left corner of the screen of handset; refer to the Handset
	status icons section on page 12 for details. If there is no network coverage, Low signal
	range will be displayed on the screen. Move somewhere until the signal shows you are under
	a strong network coverage.
	�� If the other telephones in your home are having the same problem, the problem is in the wiring
	or local service. Contact your local telephone company (charges may apply).
	�� Eliminate any background noise. Noise from a television, radio, or other appliances may cause
	the telephone to not dial out properly. If you cannot eliminate the background noise, first try
	muting the cordless handset before dialing, or dialing from another room in your home with
	less background noise.

95 www.vtechphones.com