Appendix
Replace a handset
If you want to replace a handset or reassign the designated handset number of a registered handset, you must deregister all the handsets and then individually register each handset.
To make deregistration easier, read all of the instructions below before you begin.
To deregister all handsets:
1.Press and hold 
/FIND HANDSET on the telephone base for about 10 seconds until the IN USE light on the telephone base turns on and starts to flash.
2.Press and release 
/FIND HANDSET again. You must press
/FIND HANDSET while the IN USE light is still flashing. The IN USE light flashes for approximately five seconds. If the light stops flashing, start again at Step 1.
3.All handsets show 1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS
# ON HANDSET alternately when the deregistration process completes. The deregistration process takes about 10 seconds to complete.
If deregistration fails, you may need to reset the telephone and try again.
To reset:
1.Pick up the registered handset and then press 
/FLASH.
2.Press OFF/CANCEL and place the handset back in the telephone base.
• Unplug the power from the telephone base, then plug it back in.
You cannot deregister handsets if any other system handset is in use.
39