VTech I5808 Call Waiting disconnects answering system, External Antennas, Clean Charging Contacts

Page 17

·If possible advise your callers to leave a message.

·Check with the local telephone company and advise them 7-10 seconds of silence is required for the answering system to disconnect.

NOTE: Charges may apply

Call Waiting disconnects answering system

Answering System senses a fluctuation in line voltage caused by the Call Waiting signal and disconnects.

Contact Local Telephone Company for possible solutions.

External Antennas

Additional external antennas are not recommended for the following reasons:

·AT&T cordless telephones are designed to ensure that the power output of the set does not exceed standards set by the FCC. The maximum power output allowed is .1 watt (or 100 milliwatts).

·Any attachment to a cordless telephone which increases the power output is in violation of FCC regulations.

·Once the product is opened in order to connect the external antenna, the warranty is voided.

Hearing Aid Compatibility

This product is compatible with inductively coupled hearing aids.

Use of any other amplification devices near or on the cordless product may produce squealing, whistling, or feedback.

·If you use a hearing aid in only one ear, cradle the handset to the other ear to try to avoid microphone feedback.

·Remove or turn off the hearing aid when using the handset.

·Use a different extension telephone if you are unable to use the product without assistance of a hearing aid.

Information regarding inductively coupled hearing aids:

·This type of hearing aid is usually equipped with a T (telephone ) switch, specifically installed for improved amplification with telephone use.

·Flip the T switch to the telephone position to turn off the hearing aid microphone and turn on the inductive pickup coil that receives voice signals through a magnetic field generated by some telephone handset.

·Not all telephones generate a sufficiently strong magnetic field to couple to these hearing aids.

·Those that do are labelled Hearing Aid Compatible by AT&T.

Hearing Aid Compatibility

This product is compatible with inductively coupled hearing aids.

Clean Charging Contacts

·Each month clean handset and base charging contacts using a pencil eraser or a cloth to eliminate deposit accumulation.

·Charge light should come on when handset is cradled in base. ·Charge handset for 10 hours.

Image 17
Contents Page Cordless Troubleshooting Tags De-register and register Keypad Tone Feature Vtech Telephones Keypad Tone Feature 2256/1256 2325/2365 Replace Adjust Ringer VolumeRinger On/Melody Selection Process for T2406 calls SwitchDe-Register Process for gz2434 CallsTurning Message Light Off Language Conversion Twisted Pair CordsDual-Band Frequency Language Conversion of Base Menus English Spanish VT2461 Mk1 Deregister ALL Handsets Inch 4 conductor line cord VT2461 Mk1 Deregister a Single HandsetVT2461 Mk2a Deregistration process for Access to SoundCardConference calls Operating Range GeneralCaller Id after 2nd ring Caller ID/Call Waiting ServicesOperating Range Spread Spectrum EchoDate Code Sticker Volume ControlsCardiac Pacemakers Handset Warmth ToneLengthRelocate Phone In Home EMI + Sep/Phns CrosstalkCall Waiting disconnects answering system Clean Charging ContactsExternal Antennas Hearing Aid CompatibilityRecradle unplug AC Handset Locked Up BatteryCalling in same Area Code Base Unit Locked Up Common CureSingle Audio Path Mutes Chirping SoundsLow Battery indicator Ringer Volume Not AdjustableConductor Line Corfd Explain Call WaitingDigital Voice Ringer EquivalenceJulian Date Table of Contents Important Safety Instructions Important Safety Instructions Introduction Getting Started Parts Check List GettingStatarted Handset LayoutInstallation and Charge of Battery in Handset Getting Started SetupGettingStarted Battery LifeGetting Started Registration Installation and Registration of Accessory HandsetHandset LEDs Handset IndicatorsBasic Operation Belt Clip Headset OperationAdvance Operation Maintenance Case Of Difficulty Handset does not ring when you receive a callPhone doesnt work at all No dial toneYou hear other calls while using your phone Your Handset vibrates or shakes when a call comesCommon cure for electronic equipment You cannot hear recorded messagesWhat does this limited warranty cover? Warranty StatementHow long is the limited warranty period? What is not covered by this limited warranty?Other Limitations How do you get warranty service?FCC Part FCC, Acta and IC RegulationsConnection and use with the nationwide telephone network Product identifier and REN informationRepair instructions Rights of the telephone companyIC Industry Canada Programming/testing of emergency numbersHearing aid compatibility FCC, Acta and IC Regulations Handset Technical SpecificationsIssue Need HELP?