VTech I5808 Your Handset vibrates or shakes when a call comes, You cannot hear recorded messages

Page 35

In Case Of Difficulty

Your Handset vibrates or shakes when a call comes in

It is likely that your Vibrating Handset Ringer option has been set to ON.

You hear other calls while using your phone

Disconnect your Base Unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.

You hear noise in the Handset, and none of the keys or buttons work

Make sure the power cord is plugged in.

Common cure for electronic equipment

If the unit does not seem to be responding normally, then try putting the Handset in its Base. If it does not seem to respond, do the following (in the order listed):

1.Disconnect the power to the base.

2.Disconnect the handset battery, and spare battery, if applicable.

3.Wait a few minutes.

4.Connect power to the base.

5.Re-install the battery.

6.Wait for the handset to re-establish its link with the base. To be safe, allow up to one minute for this to take place.

You cannot hear recorded messages

Using the base volume control, raise the volume to a comfortable listening level.

13

Additional Information

Image 35
Contents Page Cordless Troubleshooting Tags De-register and register Keypad Tone Feature Vtech Telephones Keypad Tone Feature 2256/1256 2325/2365 Replace Adjust Ringer VolumeRinger On/Melody Selection Process for T2406 calls SwitchDe-Register Process for gz2434 CallsTurning Message Light Off Language Conversion Twisted Pair CordsDual-Band Frequency Language Conversion of Base Menus English Spanish VT2461 Mk1 Deregister ALL Handsets Inch 4 conductor line cord VT2461 Mk1 Deregister a Single HandsetVT2461 Mk2a Deregistration process for Access to SoundCardConference calls Operating Range GeneralSpread Spectrum Echo Caller ID/Call Waiting ServicesCaller Id after 2nd ring Operating RangeDate Code Sticker Volume ControlsCardiac Pacemakers Crosstalk ToneLengthHandset Warmth Relocate Phone In Home EMI + Sep/PhnsHearing Aid Compatibility Clean Charging ContactsCall Waiting disconnects answering system External AntennasRecradle unplug AC Handset Locked Up BatteryCalling in same Area Code Chirping Sounds Common CureBase Unit Locked Up Single Audio Path MutesExplain Call Waiting Ringer Volume Not AdjustableLow Battery indicator Conductor Line CorfdDigital Voice Ringer EquivalenceJulian Date Table of Contents Important Safety Instructions Important Safety Instructions Introduction Getting Started Parts Check List GettingStatarted Handset LayoutInstallation and Charge of Battery in Handset Getting Started SetupGettingStarted Battery LifeGetting Started Registration Installation and Registration of Accessory HandsetHandset LEDs Handset IndicatorsBasic Operation Belt Clip Headset OperationAdvance Operation Maintenance No dial tone Handset does not ring when you receive a callCase Of Difficulty Phone doesnt work at allYou cannot hear recorded messages Your Handset vibrates or shakes when a call comesYou hear other calls while using your phone Common cure for electronic equipmentWhat is not covered by this limited warranty? Warranty StatementWhat does this limited warranty cover? How long is the limited warranty period?Other Limitations How do you get warranty service?FCC Part FCC, Acta and IC RegulationsRights of the telephone company Product identifier and REN informationConnection and use with the nationwide telephone network Repair instructionsIC Industry Canada Programming/testing of emergency numbersHearing aid compatibility FCC, Acta and IC Regulations Handset Technical SpecificationsIssue Need HELP?