VTech Model 6032 user manual To synchronize

Page 52

Troubleshooting

Problem	Suggestion
My cordless handset	• Make sure the power cord is securely plugged into the telephone base. Plug the unit into a
beeps and is not	different working electrical outlet not controlled by a wall switch.
performing normally.	• Move the cordless handset closer to the telephone base. It may be out of range.
	• Reset the telephone base by unplugging the unit’s electrical power. Wait for 15 seconds and
	plug it back in again. Allow up to one minute for the cordless handset and the telephone base
	to synchronize.
	• Other electronic products can cause interference to your cordless telephone. Try installing
	your telephone as far away from these electronic devices as possible: wireless routers, radios,
	radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal
	computers, kitchen appliances and other cordless telephones.

Common cure for	• If the unit is not responding normally, try putting the cordless handset in the telephone base.
electronic equipment	If it does not seem to respond, try the following (in the order listed):
	• Disconnect the power to the telephone base.
	• Disconnect the battery on the cordless handset.
	• Wait a few minutes before connecting power to the telephone base.
	• Re-install the battery and place the cordless handset into the telephone base.
	• Wait for the cordless handset to synchronize its connection with the telephone base. Allow up
	to one minute for this to take place.

48	www.vtechphones.com

Image 52

Contents User’s manual Congratulations Table of contents Table of contents Installation Parts checklistInstall handset battery Telephone base installation 800Desk/table bracket installation Dial typeIf you subscribe to DSL service Telephone settings Handset layoutTelephone settingsBasic operation Telephone base layoutDate and time Ring melodyRing volume Battery low toneOut of range tone Key toneEdit handset name LanguageClear voicemail Reset to default settings Basic operation Make, answer and end callsOptions while on calls Speakerphone MuteFind handset Advanced operation DirectoryReview the directory Search the directoryCharacter of chart Store a directory entry Dial a directory entryEdit a directory entry Delete from the directoryAbout caller ID Call log Review the call logDial a call log number Store a call log numberDelete from the call log Review redial RedialStore a redial number to the directory Dial from redial Delete from redialAnswering system operation Message capacitySet number of rings Activate the answering systemSet telephone base date and time Set telephone base ringer volume Set telephone base melodyPersonal identification number PIN Outgoing announcements Play the announcementRecord your own announcement Delete your announcementOptions during playback Message playbackDelete all messages Remote access Remote access commandsMessage window displays 02, 04, 06, 08, tSHandset and telephone base indicators Handset lightTelephone base lights Handset iconsHandset display screen messages Display WhenCheck Battery Call log display screen messagesBattery Important safety instructions Troubleshooting Problem SuggestionCharge light is off in this section Connecting For this to take place Less background noise Same outlet or near a microwave oven Company During call waiting Troubleshooting To synchronize Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC, Acta and IC regulations FCC PartIndustry Canada Rbrc seal Technical specifications Index Telephone settings 91-001156-030-100