VTech 20-2432 owner manual Installation of Battery Pack in Handset

Page 9

Getting Started

Installation of Battery Pack in Handset

		Follow the steps below:
1		1.	Remove the battery cover by
			pressing on the indent and
		2.	sliding downward.
	3	2.	Place the newbattery pack in the
	3		handset with the metal contacts
			aligned with the charge contacts
		3.	in the battery compartment.
		3.	Replace the battery cover by
		4.	sliding it upwards.
		4.	If the new battery pack is not
			already charged, place the
			handset in the base unit, or a
			remotechargingstand,andallow
			it to charge for 12 hours. After
			initial charge, a maintenance
			charge of 8 hours should be
			sufficient.

2

The original Handset that is shipped with your 20-2432 system will be automatically registered to the Base. This Handset is HANDSET 1.

As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, HANDSET 4, etc.

Whenever a charged Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset. See Registration and Operation for details.

8

Image 9

Contents Qwest Customer Service 800 Important Safety Instructions Important Safety Instructions Menu Driven Displays IntroductionParts Check List Handset Layout Line Base Unit LayoutSetup Installation of Battery Pack in Handset Charging Of Handset Battery Pack Charging Of Handset Battery PackChecking for Dial Tone Dial ToneTone/Pulse Selection For Maximum Performance of Your Cordless Telephone SystemSpare Battery Charger/Power Backup Function Registration And Operation Of The 20-2422 Accessory Handset Setup Of The 20-2422 Accessory HandsetRegistration and Operation Enter Base ID Code Handset and Base Icons Handset and Base IndicatorsDescription Handset LEDsBase LEDs LEDSetup Base Display BASE-ID Handset Settings RegisterSoft Menu Functions RDL RedialCall History Caller ID Delete Shortcut DeleteSave to Memory Handset and Base SettingsRange Tone Handset only LOW Batt Tone Handset onlyRename Enhanced ModeHandset and Base Settings Handset Deregistration RegisterMemory MemoryTo Store a Number/Name To Delete a Number/Name ToSearchForandDialaNumber NameTo Edit a Number/Name Handset and Base Operation Making CallsRedial Answering Calls EraseSave Hold Function Mute Function Flash FunctionBase Speakerphone or Headset Volume Intercom/Transfer FunctionBase Handset Global Transferring Calls Handsfree Speakerphone OperationGlobal Call from Base Low Battery Indication Switching from the Handset Earpiece to HandsfreeBase Speakerphone Operation Line in Use IndicationMessage Waiting Indication Conference CallingLine Conference Calls Handset or Base Auto Callback 3-WAY Calling Repeat Dialing Custom Pay-Per-UsePPU FeaturesCaller ID Additional ServicesCaller ID Blocking Options CallWaitingCallForwarding Voice Messaging ServiceCallRejection Call TraceSelective Call Forwarding PriorityCallSpeed Calling To Use Speed CallingHeadset Operation Headset Operation connected to the HandsetHeadset Operation connected to the Base Unit Maintenance Case Of Difficulty Handset Does Not Ring When You Receive a CallPhone Doesnt Work At All No Dial ToneCommon Cure For Electronic Equipment You Hear Other Calls While Using Your PhoneLimited Warranty FCC Part FCC, Acta and IC RegulationsProduct identifier and REN information FCC Part 68 and ActaConnection and use with the nationwide telephone network Repair instructionsProgramming/testing of emergency numbers Hearing aid compatibilityIC Industry Canada FCC, Acta and IC Regulations Nominal Effective Range Technical SpecificationsISSUE0 Table Of Contents