Motorola RMU2080 manual Microphone Gain, Hands Free without Accessories iVOX, Power Up Tone Mode

Default value is OFF. If you want to use the VOX feature, VOX level should be set at a different level.

•1 = High audio input level will trigger the Tx

•2 = Medium sensitivity

•3 = Low audio input level will trigger the Tx

Microphone Gain

The sensitivity of the microphone can be adjusted to fit different users or operating environments.

This feature can be adjusted only through the CPS. Microphone default setting is set to level 2 (medium gain).

Hands Free without Accessories (iVOX)

•Enable iVOX by pressing the PTT Button while turning ON the radio.

•A short press of the PTT Button re-enables iVOX.

•There is a short delay between the time when you start talking and when the radio transmits.

Toggle Voice Prompt in User Mode

Short press the SB1 Button while turning ON the radio to enable/disable the Voice Prompt in User Mode. (Default is set to ON).

Note: This setting is set to OFF by default and must be enabled using the CPS.

Power Up - Tone Mode

To enable/disable power up tone mode, press SB1 and SB2 buttons simultaneously for 2-3 seconds while powering up the radio until you hear the pre-programmed power up tone. 3 different power-up tones are available.

Reset to Factory Defaults

Reset to Factory Defaults will set back all radio features to the original factory default settings. To do so, press PTT, SB2 and SB1 simultaneously while turning ON the radio until you hear a high tone chirp.

GETTING STARTED

31English