Motorola RMV2080, RMU2080 manual Operating Instructions

PROGRAMMING FEATURES

Cloning Radio using the Radio to Radio (R2R) Cloning Cable (Optional Accessory)

Operating Instructions

1.Before starting the cloning process, make sure you have:

•A fully charged battery on each of the radios.

•Two Single-Unit Chargers (SUC), or 2 SUC for cloning RM Series radios, or 1 SUC for RM Series radio and 1 SUC for RDX Series radio.

•Turn OFF the radios and,

2.Unplug any cables (power supply or USB cables) from the SUCs.

3.Plug one side of the cloning cable mini USB connector to the first SUC and the other end to the second SUC.

Note: During the cloning process, no power is being applied to the SUC. The batteries will not be charged. Only data communication is being established between the two radios.

4.Turn ON the Target Radio and place it into one of the SUCs.

5.For the Source Radio, power ON the radio with the following sequence:

•Press the PTT button and the SB2 button simultaneously while turning the radio ON.

•Place the Source Radio in its SUC. Press and release the SB1 button.

6.Wait 3 seconds before releasing the buttons and you hear a distinctive audible tone saying the word “Cloning”.

7.When the cloning is completed, the Source Radio audible voice will announce either “pass”

English 50