(cloning is successful) or “fail” (cloning process has failed). If the Source Radio is a display model radio, it will either show ‘Pass’ or ‘Fail’ on the display (a voice announcement will be played within 5 seconds).
8.Once the cloning process is completed, turn the Radios OFF and ON or, long press the PTT button to exit the ‘cloning’ mode
What To Do If Cloning Fails
The radio audible voice will announce “Fail” indicating that the cloning process has failed. In the event that the cloning fails, perform each of the following steps before attempting to start cloning process again:
1.Ensure that the batteries on both radios are fully charged.
2.Check the cloning cable connection on both SUCs.
3.Ensure that the battery is engaged properly on the radio.
4.Ensure that there is no debris in the charging tray or on the radio contacts.
5.Ensure that the Target radio is turned ON.
6.Ensure that the Source radio is in cloning mode.
7.Ensure that the two radios are both from the same frequency band, same region and have the same transmission power.
Note: This cloning cable is designed to operate only with compatible Motorola SUC RLN6175 and PMLN6394.
When ordering Cloning Cable, please refer to P/N# HKKN4028_. For more information about the accessories, refer to “Accessories” on page 74.
PROGRAMMING FEATURES
51English