PROGRAMMING FEATURES
OTHER PROGRAMMING FEATURES
Scan
Scan allows you to monitor other channels to detect conversations. When the radio detects a transmission, it stops scanning and goes to the active channel. This allows you to listen and talk to people in that channel without having to change channel manually. If there are transmissions on another channel, you will not hear that activity once the radio has stopped scanning. Once the activity on transmitting channel stops, the radio waits for 5 seconds before resuming scan again.
•To start scanning, press the SB1 or SB2 button
Note: Scan has to be programmed either to SB1 or SB2 button via CPS. SB2 is by default Scan/Nuisance Channel delete button.
•To stop scanning, short press the SB1 or SB2 button (programmed for scan) again.
•By pressing the PTT button while the radio is scanning, the radio will transmit on the channel which was previously selected before Scan is
activated. If no transmission occurs within 5 seconds, scanning resumes.
•If you want to scan a channel without the Interference Eliminator Codes (CTCSS/DPL), set the code settings for the channels to ‘0’ in the CTCSS/DPL Programming Selection Mode.
Note: Whenever the radio is set to Scan, the LED Indicator blinks a Red Heartbeat.
Editing Scan List
Scan List can be edited by using the CPS. For more information refer to “Customer Programming Software (CPS)” on page 41.
English 40