Motorola RDU2080 manual What to do if cloning fails

•Both radios are turned OFF.

•Both radios are of the same radio model.

2.Unplug any cables (power supply or USB cables) from the SUCs.

3.Plug one side of the cloning cable mini connector to one SUC. Plug the other end to the second SUC.

Note: During the cloning process no power is being applied to the SUC. The batteries will not be charged. A data communication is being established between the two radios.

4.Turn ON the “Target Radio” and place it into one of the SUCs.

5.On the “Source Radio”, power the radio following the sequence below:

•Long press the Push-to-Talk (PTT) and Side Button 2 (SB2) simultaneously while turning the radio ON.

•Wait for 3 seconds before releasing the buttons until a distinctive audible tone is heard.

6.	Place the “Source Radio” in its SUC, press and
	release Side Button 1 (SB1).
7.	After cloning is completed, the “Source Radio”
	will sound either a “pass” tone (cloning was
	successful) or a “fail” tone (cloning process has
	failed). The pass tone sounds like a good key
	“chirp” whereas the “fail” tone sounds similar to
	a “bonk” tone. If the “Source Radio” is a radio
	with a display, it will either show “Pass” or “Fail”	PROGRAMMING FEATURES
	mode).
	on the display. (A tone will be heard in no more
	than 5 seconds).
8.	Once you have completed the cloning process,
	you should turn the radios “OFF” and “ON” to
	bring them to normal user mode (exit “clone”

What to do if cloning fails

The radio will emit an audible “bonk” indicating that the cloning process has failed. In the event that cloning fails, try performing each of the following before trying to start the cloning process again.

57 English