Grandstream Networks DP710 Via Tftp Server, Via Http / Https, Firmware Server Path, Password

Via TFTP Server	This is the IP address of the configured TFTP server. If selected and it is non-zero or not
	blank, the DP715 retrieves the new configuration file or new code image from the
	specified TFTP server at boot time. After 5 attempts, the system will timeout and will start
	the boot process using the existing code image in the Flash memory. If a TFTP server is
	configured and a new code image is retrieved, the new downloaded image is saved into
	the Flash memory.
	Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply)
	as this will damage the device. Depending on the local network, this process can take up
	to 15 or 20 minutes.
Via HTTP / HTTPS	The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
Server	HTTP.
	For example, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67“:6688” is
	the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
	using default port 80.
	Note: If Auto Upgrade is set to No, DP715 will only do HTTP/HTTPS download once at
	boot up.
Firmware Server Path	IP address or domain name of firmware server.
Config Server Path	IP address or domain name of configuration server.
XML Config File	The password used for encrypting the XML configuration file using OpenSSL.
Password	This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User	The user name needed to authenticate with the HTTP/HTTPS server.
Name
HTTP/HTTPS	The password needed to authenticate with the HTTP/HTTPS server.
Password
Firmware File Prefix	Default is blank. If configured, DP715 will request firmware file with the prefix. This
	setting is useful for ITSPs. End user should keep it blank.
Firmware File Postfix	Default is blank. End user should keep it blank.
Config File Prefix	Default is blank. End user should keep it blank.
Config File Postfix	Default is blank. End user should keep it blank.
Allow DHCP Option 66	If set to “Yes”, configuration and upgrade server information can be obtained using DHCP
to override server	option 66 from DHCP server located in customer’s environment. Default setting is Yes.
Automatic Upgrade	Choose “Yes” to enable automatic upgrade and provisioning. If select “Check every
	minutes” input the amount of minutes you want it to check for update. If select “Yes, daily
	at hour” make sure to input the hour of the day you want it to check for update, e.g. for 11
	pm type 23. If select “Yes, weekly on day” make sure you input the day of the week (in
	format 0-6, 0 is Sunday) you want it to check for update. When set to No, DP715 will only
	do the following option you select; “Always check for New Firmware at Boot up” will check
	for new firmware every time the device reboots. “Check New Firmware only when F/W
	pre/suffix changes” will check for updates only when the pre/suffix has been changed.
Authenticate Conf File	If set to Yes, config file is authenticated before acceptance. This protects the
	configuration from an unauthorized change.
Firmware Key	Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
	user should keep it blank.
SSL Certificate	The user specifies SSL certificate used for SIP over TLS in X.509 format.

Firmware version 1.0.0.8 DP715/DP710 User Manual Page 39 of 52