Cortelco C62 Initial Connection and Setting, Connecting the phone, Programmable key LEDs for MWI

Slow Blinking Green	The call is on hold.
Slow Blinking Red	Registration is unsuccessful.
Off	The line is not subscribed or idle.

1.6.4Programmable key LEDs for MWI

LED Status	Description
Blinking Green	There are new voice mails.
Off	There is no new voice mail.

1.6.5Power Indication LED (Power Light Enabled)

LED Status	Description
Steady red	Power on.
Blinking red	There is an incoming call.
Off	Power off.

1.6.6Power Indication LED (Power Light Disabled)

LED Status	Description
Blinking red	There is an incoming call

2 Initial Connection and Setting

2.1Connecting the phone

1.Connect to the network. Use the Ethernet cable in the package to connect the WAN port on the back of your phone to an Ethernet port. The following two figures show connection options.

a.Direct network connection—This method requires at least one available Ethernet port. Connect the WAN port on the back of your phone to the Ethernet port. Since the phone has a built-in router, it can be connected directly to the network.

b.Shared network connection—Use this method if you have a single Ethernet port which is already in use. Disconnect the Ethernet cable from the Ethernet port and attach it to the WAN port on the back of the phone. Then use the Ethernet cable in the package to connect the LAN port on the back of the phone to the other device. The IP Phone now shares a network connection.

11