2.Use the navigation keys to highlight the line for which you want to set voicemail.
3.Press Edit
4.Use the navigation keys to enable voicemail.
5.Input the number. Press 2aB softkey if necessary to change the input method.
6.Press Save to save the change.
7.To hear a new voicemail, press the Voicemail softkey. Then press Dial. It may then be necessary to enter a password.
4.8.4Ping
1.Press
2.Enter the IP Address to be pinged.
3.Press Start
4.Display will show “Ping IP Address”
5.After approximately 5 seconds, the display will show “OK” if the ping is successful or “Failed” is the ping is unsuccessful.
4.9Programmable Key Configuration
The phone has 4 programmable keys which can be set to various functions. The functions are discussed in the following sections. The default configuration for each key is None which means the key has not been set for any function.
To configure any function
1.Press
2.Choose Line Key Settings or Function Key Settings.
3.Use the UP ARROW or DOWN ARROW to choose the key.
4.Use LEFT ARROW or RIGHT ARROW to choose the function.
4.9.1Memory Key
1.Use the UP ARROW or DOWN ARROW keys to move to Tel.
2.Enter the number to be stored.
3.Press SAVE.
4.9.2Line
Access a SIP or IAX2 line registered to the phone.
1.Use the UP ARROW or DOWN ARROW keys to move to Line.
2.Use LEFT ARROW or RIGHT ARROW to select the Line.
3.Press SAVE.
4.9.3Key Event
This subtype has many options. They are listed below along with brief explanations.
19