Chapter 55 Configuring a VoIP Network
Using SmartPorts
All ingress and egress QoS scheduling parameters configured on all ports. CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps configured. Global QoS configured.
Port 3/1 ingress QoS configured for Cisco IP Phone. Macro completed on port 3/1.
Console> (enable)
If you do not specify an auxiliary VLAN, the following warning message displays:
Console> (enable) set port macro 3/1 ciscoipphone vlan 2
Warning: All inbound QoS tagging information will be lost as no auxiliary vlan was specified.
Do you want to continue (y/n) [n]?
ciscosoftphone Command Output
When you enter the ciscosoftphone keyword, the following displays:
Console> (enable) set port macro 3/1 ciscosoftphone vlan 32
Port 3/1 enabled.
Layer 2 protocol tunneling disabled for CDP STP VTP on port(s) 3/1.
Port 3/1 vlan assignment set to static.
Spantree port fast start option set to default for ports 3/1.
Port(s) 3/1 channel mode set to off.
Warning: Connecting Layer 2 devices to a fast start port can cause temporary spanning tree loops. Use with caution.
Spantree port 3/1 fast start enabled.
Dot1q tunnel feature disabled on port(s) 3/1.
Port(s) 3/1 trunk mode set to off.
Vlan 32 configuration successful
VLAN 32 modified.
VLAN 2 modified.
VLAN Mod/Ports
----
32 3/1 16/1
Port 3/1 will not send out CDP packets with AuxiliaryVlan information. Executing autoqos........
All ingress and egress QoS scheduling parameters configured on all ports. CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps configured. Global QoS configured.
Port 3/1 ingress QoS configured for Cisco Softphone. Macro completed on port 3/1.
Console>> (enable)
Detailed SmartPorts Statements
These sections provide the detailed SmartPorts macro statements:
•ciscoipphone Macro Statement, page
•ciscosoftphone Macro Statement, page
| Catalyst 6500 Series Switch Software Configuration |
|