HP 7000 dl Router manual Hdlc Command SET, Hdlc Command Set

SROS Command Line Interface Reference Guide HDLC Command Set

HDLC COMMAND SET

To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt. For example:

>enable

#configure terminal (config)#interface hdlc 1 (config-hdlc 1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 813 bandwidth <value> on page 816 bridge-group <group#> on page 817 crypto map <mapname> on page 818

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 820

fair-queue <threshold> on page 822 hold-queue <queue size> out on page 823 ip commands begin on page 824 keepalive <seconds> on page 841

lldp receive on page 842

lldp send [management-address l port-description l system-capabilities l system-description l system-name l and-receive]on page 843

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 811