HP 7000 dl Router manual Enable Mode Command SET, Sros Command Line Interface Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

ENABLE MODE COMMAND SET

To activate the Enable Mode, enter the enable command at the Basic Mode prompt. (If an enable password has been configured, a password prompt will display.) For example:

Router>enable

Password: XXXXXXX

Router#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the section listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

clear commands begin on page 22 clock auto-correct-dston page 48

clock set <time> <day> <month> <year> on page 50 clock timezone <text> on page 51

configure on page 53

copy <source> <destination> on page 54 copy console <filename> on page 55 copy flash <destination> on page 56

copy <filename> interface <interface> <slot/port> on page 57 copy tftp <destination> on page 58

copy xmodem <destination> on page 59 debug commands begin on page 60 dir on page 98

disable on page 99

erase [<filename> startup-config]on page 100 events on page 101

logout on page 102

reload [cancel in <delay>] on page 103 show commands begin on page 104 telnet <address> on page 194

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 20