HP 7000 dl Router manual Attribute policynumber

SROS Command Line Interface Reference Guide IKE Policy Command Set

attribute <policynumber>

Use the attribute command to define attributes for the associated IKE policy. Multiple attributes can be created for a single IKE policy. Once you enter this command, you are in the IKE Policy Attribute . Refer to IKE Policy Attributes Command Set on page 386 for more information.

Syntax Description

<policynumber>	Assign a number (range: 1-65535) to the attribute policy. The number is the
	attribute's priority number and specifies the order in which the resulting VPN
	proposals get sent to the far-end.
	This command takes you to the (config-ike-attribute)#prompt. From here, you
	can configure the settings for the attribute as outlined in the section IKE Policy
	Attributes Command Set on page 386.

Default Values

By default, no attribute is defined.

Command Modes

(config-ike)# IKE Policy Configuration Mode

Functional Notes

Multiple attributes on an IKE policy are ordered by number (with the lowest number representing the highest priority).

Usage Examples

The following example defines a policy attribute (10) and takes you into the IKE Policy Attributes :

(config-ike)#attribute 10 (config-ike-attribute)#

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 374