SROS Command Line Interface Reference Guide

IKE Policy Command Set

 

 

nat-traversal <version> [allow disable force]

Use the nat-traversalcommand to allow, force, or disable NAT traversal version 1 and 2 on a specific Ike policy.

Syntax Description

<version>

Enter v1 or v2 to select the NAT traversal version.

allow

Sets the Ike policy to allow the specified NAT traversal version.

disable

Sets the Ike policy to disable the specified NAT traversal version.

force

Sets the Ike policy to force the specified NAT traversal version.

Default Values

The defaults for this command are nat-traversal v1 allow and nat-traversal v2 allow.

Command Modes

(config-ike)#

Ike Policy Configuration Mode

Usage Examples

The following example disables version 2 on Ike policy 1:

(config)#crypto ike policy 1 (config-ike)#nat-traversal v2 disable

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

382

Page 382
Image 382
HP 7000 dl Router manual Nat-traversal version allow disable force, Following example disables version 2 on Ike policy