HP 7000 dl Router manual Tunnel Configuration Command SET, Tunnel Configuration Command Set

Command Reference Guide Tunnel Configuration Command Set

TUNNEL CONFIGURATION COMMAND SET

To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global Configuration mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface tunnel 1

Router(config-tunnel 1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 779 bandwidth on page 782

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 783

ip commands begin on page 786

keepalive <period> <retries> on page 803 tunnel commands begin on page 804

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 778