HP 7000 dl Router manual Loopback dte line remote, Dte, Remote

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set

loopback [dte line remote]

Use the loopback command to initiate a specified loopback on the interface. Use the no form of this command to deactivate the loop.

Syntax Description

dte	Initiates a loop to connect the transmit and receive path through the unit.
line	Initiates a loop of the DDS circuit towards the network by connecting the transmit
	path to the receive path.
remote	Transmits a DDS loop code over the circuit to the remote unit. In response, the
	remote unit should initiate a line loopback.

Default Values

No default values necessary for this command.

Command Modes

(config-dds 1/1)# 56K/64K (DDS) Interface Configuration Mode required

Usage Examples

The following example activates a line loopback on the DDS interface:

(config)#interface dds 1/1 (config-dds 1/1)#loopback line

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 490