SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

frame-relay interface-dlci <dlci>

Use the frame-relayinterface-dlcicommand to configure the Data Link Connection Identifier (DLCI) for the Frame Relay sub-interface. This setting should match the DLCI supplied by your Frame Relay service provider. Use the no form of this command to remove the configured DLCI.

Syntax Description

<dlci>Enter numeric value supplied by your provider

Default Values

<dlci>

The default DLCI is populated with the sub-interface identifier. For example, if

 

configuring the virtual Frame Relay sub-interface labeled fr 1.20 , the default DLCI

 

is 20.

Command Modes

(config-fr 1.1)#

Virtual Frame Relay Sub-Interface Configuration Mode required

Usage Examples

The following example configures a DLCI of 72 for this Frame Relay endpoint:

(config)#interface fr 1.16

(config-fr1.16)#frame-relay interface-dlci 72

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

616

Page 616
Image 616
HP 7000 dl Router manual Frame-relay interface-dlci dlci, Config#interface fr Config-fr1.16#frame-relay interface-dlci