HP 7000 dl Router manual Clear ip policy-sessions

SROS Command Line Interface Reference Guide Enable Mode Command Set

clear ip policy-sessions

Use the clear ip policy-sessionscommand to clear policy class sessions. You may clear all the sessions or a specific session. Refer to the show ip policy-sessionsfor a current session listing. The following lists the complete syntax for the clear ip policy-sessionscommands:

clear ip policy-sessions

clear ip policy-sessions <classname> [ahp esp gre icmp tcp udp <protocol>] <source ip> <source port><dest ip><dest port>

clear ip policy-sessions <classname> [ahp esp gre icmp tcp udp <protocol>] <source ip> <source port><dest ip><dest port> [destination source] <nat ip><nat port>

Syntax Description

<classname>	Alphanumeric descriptor for identifying the configured access policy (access
	policy descriptors are not case-sensitive).
<protocol>	A specific protocol (valid range: 0-255).
<source ip>	Specifies the source IP address (format is A.B.C.D).
<source port>	Specifies the source port (in hexadecimal format for ahp, esp, and gre; decimal for
	all other protocols).
<dest ip>	Specifies the destination IP address (format is A.B.C.D).
<dest port>	Specifies the destination port (in hex format for ahp, esp, and gre; decimal for all
	other protocols).
[destination source]	For NAT sessions, this specifies whether to select a NAT source or NAT
	destination session.
<nat ip>	For NAT sessions, this specifies the NAT IP address (format is A.B.C.D).
<nat port>	For NAT sessions, this specifies the NAT port (in hex format for ahp, esp, and gre;
	decimal for all other protocols).

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Functional Notes

The second half of this command, beginning with the source IP address may be copied and pasted from a row in the show ip policy-sessionstable for easier use.

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 35