HP 7000 dl Router manual Router ospf, Config#router ospf config-ospf#

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

router ospf

Use the router ospf command to activate OSPF in the router and to enter the OSPF Configuration Mode. See the section Router (OSPF) Configuration Command Set on page 903 for more information. Use the no form of this command to disable OSPF routing.

Syntax Description

No subcommands.

Default Values

By default, OSPF is disabled.

Command Modes

(config)# Global Configuration Mode required

Functional Notes

The Secure Router OS can be configured to use OSPF with the firewall enabled (using the ip firewall command). To do this, configure the OSPF networks as usual, specifying which networks the system will listen for and broadcast OSPF packets to. See ip firewall on page 271 for more information.

To apply stateful inspection to packets coming into the system, create a policy-class that describes the type of action desired and then associate that policy-class to the particular interface (see ip policy-class <policyname> max-sessions <number> on page 293). The firewall is intelligent and will only allow OSPF packets that were received on an OSPF configured interface. No modification to the policy-class is required to allow OSPF packets into the system.

Usage Examples

The following example uses the router ospf command to enter the OSPF Configuration Mode:

(config)#router ospf (config-ospf)#

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 331